SIKORA ULTRATEMP 6000
Ultrasonic measurement of PE melt temperature between the extruder and the crosshead
SIKORA ULTRATEMP 6000 uses ultrasound to measure, without contact and non-invasively, the temperature of polyethylene melt in the flow channel between the extruder and the crosshead. It helps prevent scorch, premature crosslinking and unmelted material, and to optimize extruder output.
Benefits
- Non-contact, non-invasive temperature measurement based on ultrasound
- Maximum extruder output thanks to optimum melt temperature
- Elimination of scorch and premature crosslinking in the extruder head
- Prevention of melt discolouration and of unmelted material
- Detection of inhomogeneities in the melt
- Unaffected by shear heating of the melt
- Measuring accuracy ±1 °C
- Optional Profinet IO, Profibus-DP and analogue output interfaces
- Polyethylene melts
- Extrusion of XLPE cable insulation
- Melt temperature measurement between the extruder and the crosshead
We supply the equipment configured for your application. In your inquiry, please state the material processed, the required throughput and the line parameters – we will prepare a tailored quotation.
Need help choosing? Call us on +420 571 647 228 or write to info@azurr-tech.cz.
Technical data
| Measuring principle | Non-contact, non-invasive temperature measurement based on ultrasonic technology |
|---|---|
| Measuring point | flow channel between the extruder and the crosshead |
| Measuring range | +100 to +180 °C |
| Measuring accuracy | deviation ±1 °C |
| Interface | RS485, RS232 (diagnostics); optionally Profinet IO, Profibus-DP, analogue output |
| Power supply | 100–240 V AC ±10 %, 50/60 Hz |
| Display units | DISPLAY 2000, ECOCONTROL series |
Description
SIKORA ULTRATEMP 6000 is an ultrasonic system for measuring the temperature of polyethylene melts. It reliably measures the melt temperature in the flow channel between the extruder and the crosshead, thus providing one of the essential process parameters.
Based on the measurement, it is possible to avoid a temperature that is too high, which leads to melt discolouration or the formation of scorch, as well as a temperature that is too low, which causes unmelted material. The measurement is non-contact and non-invasive, so there is no shear heating of the melt; the system also reveals inhomogeneities in the melt.
ULTRATEMP 6000 thus contributes significantly to process optimization and cost reduction. The measured values can be shown on the DISPLAY 2000 display unit or on ECOCONTROL series units.
Optional equipment
More products in this category
SIKORA PREHEATER 6000 TC
Conductor preheater with non-contact conductor temperature measurement and controlAll versions in the Temperature, length and preheating category (3 items)