Another manufacturer’s sensor? We’ll find a Dynisco equivalent.

Enter what you know about your sensor or process and you’ll see suitable Dynisco pressure sensors from our range straight away. If you’re not sure, send us the model code from the label. A technician will identify the parameters and propose a replacement.

Replacement finder

Find a replacement by its parameters

Nothing is mandatory. The more you fill in, the more precise the selection. For each result you’ll see which parameters match your requirements and which differ.

Know the sensor type?

Enter the code from the label of a Gefran, Gneuss, Bagsik, Terwin, BCM or Gräff sensor. We’ll read its parameters and fill them in the finder.

Application
Process connection
Output signal
Pressure range
Melt or medium temperature
°C
Medium and operating conditions
More parameters

Loading Dynisco sensors…

Not sure which to choose? A technician will check your requirements and recommend a replacement.

Send requirements to a technician

✓ matches · ! differs · ? we will verify The data is based on Dynisco datasheets and ordering codes and will be checked by a technician before you order. Some special versions are not included in the finder because we have not verified all their data. Send us your requirements and a technician will look them up.

Series we replace most often

Gefran, Gneuss, Bagsik and others

Gefran sensors

K, I, M, W, H and IL series – melt pressure transducers with a rigid stem or capillary and mV/V, mA or V output.

Bagsik sensors

CDA, CDAI, CDTA and CDTAI series – including versions with an integrated temperature sensor.

Gneuss sensors

DA, DAI, DTA and DTAI series, plus DAIH, DAP, DAIP, DAIX, DAIL and DTAIL – decoded from the manufacturer’s ordering code.

Terwin, BCM and Gräff

Terwin 2000 and Ultra-MAX, BCM MPT260–MPT263. For Gräff sensors we identify the series and our technician confirms the details.

Other manufacturers

We also replace sensors from other manufacturers. What matters is the process connection, range, output signal and stem or capillary length.

Urgent cases

If your line is down, say so in your message or give us a call. We’ll do everything we can to get the replacement to you as quickly as possible.

Process

How it works

  1. Send the code

    The model code from the label – ideally with a photo of the sensor and its connector.

  2. Identification

    A technician decodes the parameters: range, connection, lengths, signal and fill.

  3. Replacement proposal

    We offer a Dynisco equivalent and point out any differences.

  4. Delivery

    We deliver the sensor and, if you wish, help with installation and set-up.

No-obligation enquiry Identification and the replacement proposal are free of charge. The decision to order is always yours.

Identifier

Let us find a replacement for your sensor

Write the model code from the sensor label in the message of your inquiry, or add the Dynisco sensor selected in the finder to your inquiry. You can send a photo of the label to info@azurr-tech.cz; if it is urgent, call +420 571 647 228.

Send us the sensor code